WeldCyprus
ALL CYPRUS // 120 · 150 · 200 LITRES

A solar heater frame
for a flat roof
and for tiles.

A full tank weighs twice what an empty one does: two hundred litres is two hundred kilograms on four feet, with the wind on top of it. The frame is welded for your tank, your roof and your angle.

120–200 LITRES FLAT AND PITCHED HOT-DIP GALVANISED WIND BRACING LIFTED UP FOR YOU
Welder in a mask making a TIG weld on a steel box section, close-up
from €350
PER FRAME
4
WORKING DAYS
200 kg
FULL TANK WEIGHT
30–45°
COLLECTOR ANGLE

Worth deciding before you order

/ 01

A full tank weighs as much as two people

Two hundred litres of water is around two hundred kilograms carried on four feet. On a flat roof they cannot go just anywhere: the load has to land on the slab or a beam, not on screed over a void.

/ 02

Wind lifts the collector

The face of the collector works like a sail. Winter gusts on the coast reach storm strength, and a frame without bracing starts to walk, chewing out its anchor holes. Two diagonal ties cost little and end the question.

/ 03

Galvanising, not paint

The frame sits under water that occasionally drips and under sun all year. Paint on a roof lasts three or four seasons; after that the rust works underneath the tank, where nobody sees it until the tank shifts.

Build it to your size

Pick the tank, the roof and the frame width — the price follows. The configuration stays in the page address, ready to save or send to me.

Typical configurations and prices

Why the price here is approximate

What the page works out is an estimate, not a quote. The final figure is always worked out separately, because the same structure in two different places does not cost the same.

  • How easy the spot is to reach, and whether the van and the gear fit.
  • What it stands on and bolts to: wall, concrete, roof, soil — the condition of the base changes the job.
  • Where reinforcement is needed and where it can be done more simply — and come out cheaper.
  • How fast you need it, and how much preparing the site takes.

This is not factory production, where everything comes out identical, soulless and at the lowest price. Each piece is made for your particular spot. Write to me — we will go through where reinforcement is worth it and where it is not, and I will find an option that suits you.

SEND THIS CONFIGURATION TO WHATSAPP

More from the catalogue

/ 01 7 working days

Table

A steel frame built for the top you choose: oak, HPL compact, concrete or glass. Galvanised when it lives outdoors.

Oak 40 mm HPL compact 12 mm Concrete over steel Hot-dip galvanised
from €350 CONFIGURE
/ 02 5 working days

Bench

Bench with or without a backrest, timber or checker-plate seat. Pairs with the table or stands alone by the pool.

With backrest Oak Hot-dip galvanised
from €300 CONFIGURE
/ 03 7 working days

BBQ grill

A fixed BBQ in 3–6 mm steel: open, with a lid, or with a chimney. Thick steel does not warp in the heat.

6 mm With chimney Side table Wheels
from €400 CONFIGURE
/ 04 5 working days

Outdoor shower

A shower post by the pool or at the beach house. Galvanised, aluminium or stainless — next to salt water that is not decoration.

Stainless AISI 304 Timber deck Hot-water mixer
from €500 CONFIGURE
/ 05 2 working days

A/C bracket

Bracket for the outdoor unit: up to 12,000, 18,000 BTU or more. With an anti-theft cage if the unit sits on the ground floor.

Hot-dip galvanised Stainless AISI 304 Anti-theft cage
from €150 CONFIGURE
/ 06 4 working days

Roof ladder

Ladder to the roof for the boiler and the aerials: straight, with a safety cage, or with a removable lower section.

With safety cage Hot-dip galvanised Top platform
from €300 CONFIGURE

Frequently asked

What does a solar heater frame cost?
A galvanised frame for a 120 litre tank on a flat roof is around €400. For 200 litres on tiles, around €550. With bracing and lifting onto the roof, around €750. The simplest ground-level frame starts at €350.
Will you remove the old frame?
Yes — tick it in the calculator. Old frames are usually rusted through at the feet, and they come off together with the heater, so the work is planned for the morning and the water is hot again by evening.
Do you install the heater too?
I make and fit the frame; the tank and collector go up and get strapped down together, and the pipework and drain are a plumber job. If the heater already exists, we take it off, change the frame and put it back the same day.

Order — Solar heater frame

How to reach me

Call +357 99 230 862

Fastest way: send a photo of the job to WhatsApp or Telegram — you get a price within the hour.

PHONE / WHATSAPP
+357 99 230 862
TELEGRAM
@welder_cyprus
BASE
Larnaca, Cyprus
Installation across Cyprus
HOURS
Mon–Sat 08:00–20:00